Using Brew for testing | developer.brewmp.com Using Brew for testing | developer.brewmp.com

Developer

Using Brew for testing

Forums:

i want to use brew for testing mobile phones

i would be highly thankful for any kind of techincal assistance for the following queries:

1. Is there is any possibility of using Brew Api to communicate directly with lower layers (e.g Layer 3) for exchanging some messages, e.g. for dialing a number or sending SMS, Switch On & OFF messages. without using AT commands.

2. Can I use Brew Api's and communicate directly between the PC and the QualComm Stack on the phone via USB.

thanks

Not sure I understand your question clearly. However,
1. You can use ITAPI interface to send SMS, or dial phone etc.
2. To communicate between PC and phone, you could use BITL API, please note that BITL is available from BREW 3.1.3 onwards.
3. For pre 3.1.3 versions, you can do very limited things via grinder/shaker perl API.

Not sure I understand your question clearly. However,
1. You can use ITAPI interface to send SMS, or dial phone etc.
2. To communicate between PC and phone, you could use BITL API, please note that BITL is available from BREW 3.1.3 onwards.
3. For pre 3.1.3 versions, you can do very limited things via grinder/shaker perl API.

hello ruben,
Thanx a lot for the reply i will try with the TAPi API but i am not able to find the BITL API which u mentioned to communicate between phone and Pc . I am using version 3.1.5.27. I searched in APi reference but failed.
thanx for all help and support :)

hello ruben,
Thanx a lot for the reply i will try with the TAPi API but i am not able to find the BITL API which u mentioned to communicate between phone and Pc . I am using version 3.1.5.27. I searched in APi reference but failed.
thanx for all help and support :)