Resources | developer.brewmp.com Resources | developer.brewmp.com

Developer

resources

Validation of flip

Porting Validation Suite (PVS) to verify device support for the flip feature on a clamshell mobile device.

Use these PVS OAT modules to validate device support for the flip feature on a clamshell mobile device

OAT Validation performed
Device_ClamClosedAppStart.1 Starts an application while the clamshell is closed. Prompts the user to close the clamshell and wait for 1 minute. The OAT should restart while the clamshell is closed. When the OAT is resumed, the user is asked if the OAT restarted while the clamshell was closed.
Device_ClamClosedDataCall.1 Makes a data call while the clamshell is closed. Verifies whether a data call can be made when the clamshell is closed. Prompts the user to close the clamshell and wait until a beep is heard. This test also logs whether the beep or timers don't work when the clamshell is closed. The user should open the clamshell if the beep isn't sounded for more than approximately 2 minutes.
Device_ClamClosedDrawText.1 Draws on a secondary display while the clamshell is closed. Prompts the user to close the clamshell and verify that the "Hello" string is visible on the secondary display. After opening the clamshell, the Pass/Fail/Retry menu appears.
Device_ClamShell.1 Verifies the behavior of closing and opening the clamshell on a mobile device when Brew MP is active.

Other documentation

See the PVS Test Case Reference for more information on the OAT modules.